View Profile: JayPoorJay - CafeRacer Forums
Close

No Recent Activity
About JayPoorJay

Basic Information

Statistics


Total Posts
Total Posts
36
Posts Per Day
0.09
General Information
Last Activity
02-07-2019 03:14 PM
Join Date
11-11-2018
Referrals
0

8 Likes

  1. JayPoorJay
    JayPoorJay liked post by TrialsRider On thread : This is where Im at...
    I think it's safe to say that everybody here learned the hard way.
    Liked On: 11-20-2018, 12:33 PM
  2. JayPoorJay
    JayPoorJay liked post by Geeto67 On thread : This is where Im at...
    Randakk is a GL specalist, although he is more focused on the early ones: https://www.randakks.com/ I also use Hondaparts-direct.com for OEM honda parts. Never had a problem. There are lots of...
    Liked On: 11-20-2018, 12:33 PM
  3. JayPoorJay
    JayPoorJay liked post by Cyorg On thread : This is where Im at...
    Then instead of air, you rig up the master cylinder so you can hydraulic them out with brake fluid.... (for when you don't have a compressor or they are really stuck). Edit. Or bicycle pump ffs....
    Liked On: 11-19-2018, 07:55 PM
  4. JayPoorJay
    JayPoorJay liked post by Cyorg On thread : This is where Im at...
    If you used those pliers to pull the pistons out, then you get a digital kick in the nuts. Best way is to remove the pads and then put a piece of wood in place of them. It should be thick enough that...
    Liked On: 11-19-2018, 07:50 PM
  5. JayPoorJay
    JayPoorJay liked post by Teazer On thread : This is where Im at...
    Before you go hacking into the wiring loom, try testing the thermo switch and see if it works. Assuming you can remove it, check resistance across the terminals or if it has one terminal, between...
    Liked On: 11-19-2018, 07:23 PM
  6. JayPoorJay
    JayPoorJay liked post by TrialsRider On thread : This is where Im at...
    Carbs are easy enough, the problems on low milage carbs will all be in the very bottom and lessen as you go up from there, because the old fuel residue settles as the fuel level lowers from...
    Liked On: 11-19-2018, 07:23 PM
  7. JayPoorJay
    JayPoorJay liked post by Cyorg On thread : This is where Im at...
    For the sticking float, you could remove the float bowl drain screw on the offending carb and spray a decent amount of carb cleaner in there. It is pretty hit and miss not to mention messy. Sometimes...
    Liked On: 11-19-2018, 07:22 PM
  8. JayPoorJay
    JayPoorJay liked post by TrialsRider On thread : This is where Im at...
    Blue black or white smoke? and do you use a side stand? horizontal motors are prone to oil leaking past the oil scraper ring when they are parked with the cylinders lower then the oil in the...
    Liked On: 11-19-2018, 07:22 PM