FR- Torque spec fer tor, SON!
Close

FR- Torque spec fer tor, SON!

This is a discussion on FR- Torque spec fer tor, SON! within the Technical forums, part of the Caferacer.net Forums category; hold the applause, not my own, just a dirty re-post: "The torsion bars should read 60 inch-pounds as a minimum, (deflecting them from neutral pressure ...

Results 1 to 2 of 2
  1. #1
    Moderator ROSKO's Avatar
    Join Date
    Feb 2005
    Location
    New York, New York, Australia.
    Posts
    3,065

    FR- Torque spec fer tor, SON!

    hold the applause, not my own, just a dirty re-post:

    "The torsion bars should read 60 inch-pounds as a minimum, (deflecting them from neutral pressure to alignment with the guide tube that retains the end.).... I have found most will read about 75/80 inch-pounds unless they have been over-revved..... "

    Haven't found any "new" specs but, better to have something...

    BORN TO LURK, FORCED TO WORK.

  2. #2
    FR
    FR is offline
    Senior Member FR's Avatar
    Join Date
    Nov 2004
    Location
    Essex Jct, VT, USA.
    Posts
    2,595
    Well good job fishing that out of the cesspool. Thanks.



    FR


Sponsored Links

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Similar Threads

  1. proper torque
    By coreyjdl in forum General
    Replies: 1
    Last Post: 05-08-2011, 11:32 AM
  2. Critical Torque
    By catboy in forum Technical
    Replies: 17
    Last Post: 05-06-2011, 08:58 AM
  3. cb350 swing arm torque spec
    By 736cafe in forum Technical
    Replies: 4
    Last Post: 04-23-2009, 12:41 AM
  4. Torque Wrench?
    By ZouLou in forum Technical
    Replies: 10
    Last Post: 11-27-2008, 05:10 PM
  5. Torque and cool! (but not really a cafe)
    By Eurago in forum General
    Replies: 7
    Last Post: 08-12-2008, 10:47 PM