Cafe Racer Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
1st of all sorry if I'm doing this wrong (I'm new to forums)
I recently got my 72 Suzuki gt550 engine cases back together, the kickstarter shaft I noticed is sticking out too far, (about 1 cm) so if I try to pre load the tension, it pops out a little and all the tension gets lost. Also the ratchet doesn't make contact, and the clutch cover won't go all the way on with the shaft sticking out that far. Is there any chance it can be pushed in. Or did I somehow knock the spring out of the notch it sits in when I put the cases back together. I'm at a loss here it seems to be perfect minus the shaft being or too far. (thanks for any help.)
 

·
Registered
Joined
·
88 Posts
Does it it look something like this? This is from my gs 550, don't no know if it's the same or not. But it sounds like a circle clip might of come off or wasn't installed properly. 20151212_114039.jpg 20151212_114029.jpg
 
1 - 2 of 2 Posts
Top