Cafe Racer Forum banner

CB 350 headgasket for dummies saga cont.

915 Views 3 Replies 3 Participants Last post by  joe c
So I have put the piston's in upside down and when I get an extra set of hands I'm going to put them on the arms. BUT my question is looking at my manual I see these "Oil gallery O-ring" but in my clymer (sucks) it doesn't say where these come out or go back in.
http://img102.echo.cx/my.php?image=dsc029642ne.jpg

The O-rings that come in my top end kit are much larger than any holes that appear where oil would be coming up through. Does anyone have any experience with these litter buggers ?

http://img47.echo.cx/my.php?image=dsc029631kx.jpg

Last thing I want to do is have this thing back together and have it pissing oil on you guys as you pass me.
Thanks

J "not that" D
1 - 1 of 4 Posts
O-rings usually go around the dowels I was telling you about. I think on most Honda head gaskets you can tell which ones take it by the size.

Aaron
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top