Cafe Racer Forum banner
Cancel

cb 550 with 750 pistons ??????

1017 Views 4 Replies 3 Participants Last post by  Geeto67, 
W
is it posible to fit cb750 pisotns in a cb550 with only mach the cylinders? HAS ANYBODY DONE THIS.IF SO HOW MUCH IMPROVEMENT IN HORSE POWER.

cafe racers!!!!!
bobbers!!!!!!
Reply
Save
Like
1 - 2 of 5 Posts
J
If you have enough room in the liners to bore them out enough, and if the wrist pin diameter is the same, and the deck height the same, and the valve reliefs very similar, and the dome close enough to fit or be machined....yeah why not.
JohnnyB
Reply
Save
Like
J
If you have enough room in the liners to bore them out enough, and if the wrist pin diameter is the same, and the deck height the same, and the valve reliefs very similar, and the dome close enough to fit or be machined....yeah why not.
JohnnyB
Reply
Save
Like
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cafe Racer Forum
A forum community dedicated to Cafe Racer style race bikes owners and enthusiasts. Come join the discussion about restoration, performance, racing, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Bike Discussions Project Builds Technical Vintage Motorcycle Racing New Member Introductions
Top