Cafe Racer Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter #1
what the trick/procedure for installing the headers on a cb twin? I bought a gasket set, which only came with two copper crush gaskets, which wouldnt work, since the pipe didnt sit in far enough to crush the gasket. later i found it more than likely takes two gaskets for each side, but still they didnt crush. Im pretty sure im installing the pieces that hold the bracket (that bolts to the head) on right, and they brackets tighten up good and flat, but the pipes are loose enough to twist around, and after having to remove one of the headers, neither of the 2 gaskets of that side even started to crush.

what am i doing wrong?
 

·
Registered
Joined
·
55 Posts
Discussion Starter #3
i actually had those pieces, i just had the collars fipped around the wrong way. doh! thanks
 
1 - 3 of 3 Posts
Top