Hello everyone. I’ve rebuilt my CB200 to a cafe style bike. My question is I’ve looked high and low for this gas cap. I was wondering if someone has some idea where I can buy one. I have attached photos.
I can't imagine that that gage would be very accurate or helpful even at it's best. You could maybe gut it and stick one of those little clocks in it and repurpose it that way? I don't know how well it would hold up so close to gas but maybe?
Hey all, new here. Just got myself a 72’ Honda CB100 with a CL100 engine swap. Im replacing the lighting and fenders, but I’m running into an issue with finding compatible lights. Everything that I’ve found that is low profile runs on 12v, but the bikes battery is only 6v. Haven’t done a TON of...
Hello all............recently put a new battery in my 69 cb175. Battery died after a week or so. I only rode it for a total of an hour within that time. It usually takes 6 cranks with starter to get her going so i imagine that's draining the battery significantly. I also have an H4 type bulb...
Is anyone running an older DR650 as a stripped down trail bike or desert sled?
I am currently working on one, and trying to find a good exhaust, tire and seat setup. Open to input and suggestions.
In general, will mounting tires sized (110/90 -18F) and (120/90 – 18R) make a difference one way or another if a bike has tire/rim sizes to accept (100/90 -18 F) and (110/90 – 18 R) stock by the manufacturer? No clearance issues being a prerequisite.
Working on a bike that has a sorted history. Don't know any more about the motor other than it is a '83 or '84 CB or CM 450. Trying to figure out if we need a CDI when rewiring with a Motogadget M Unit?
Would appreciate help as we try to determine a wiring diagram.