[RookieGeorge]

So I've got new stand-alone brake and clutch levers, but now I need a throttle that's stand-alone. Does anyone have a part that works with the stock CB carbs? I was thinking of something along the lines of Motion-Pro's kits: http://www.motionpro.com/motorcycle/controls/cr_pro_throttle/ Straight-pull, 1/4 turn, voodoo incantation, I know it's not this complicated!
Thanks.

 

[krapfever]

I'm pretty sure a 1/4 turn throttle won't work with stock carbs.

Honda go sideways!

 

[ROBFROMMINNESOTA]

i need a new throttle assem. for my cb350 too!


where can i get a clean looking one!??!?

72' CB350, 80' CM400

 

[fuzzybutt]

i use a motion pro throttle on my cb750, push/pull and it fits the stock cables too. i got mine from the cycle exchange

some people are like slinkies, basically useless but they still make me smile when i push them down the stairs

 

[RookieGeorge]

I was going to cheat and use the same one on the 360 up at the Shop but they've got flatsides on it and I figure it's a different length. So now I'm back to the stocker for the moment. It'll let me measure the required pull, though, so I'll get the measurement and take a stab at a CR unit based on that. I'll post up the part information once I get it worked out.

 

[ProTeal55]

I have a 1/4 turn pit-bike throttle on my CB450 at the moment.

It does work, but is WAY too touchy for my liking. Going to pull the front brake was intresting to say the least.I allready got another regular one outta the Drag Specialties catalog on it's way.

ProTeal55
Member: Ton-Up Club Chicago
1972 CB750 Hooligan/Street Fighter
1974 CB/CL450 Cafe/Bar/Stripclub Racer
1955 Chevrolet Bel-Air Hardtop

 

[kenessex]

I am using this one from Dennis Kirk.
http://www.denniskirk.com/jsp/produ...d=115&productId=p51247&leafCatId=11510&mmyId=
It works with the stock CB350 throttle cable.

Ken

AHRMA 412
Vintage racing - old guys on old bikes

 

[RookieGeorge]

Bango! Now that's what I needed. Thanks!