CB350 engine installation

7266 Views 15 Replies 9 Participants Last post by texmawby, Dec 1, 2006

Discussion Starter · Nov 29, 2006

I'll be installing my CB350 race engine into the frame Friday. It was difficult removing, any hints on an easier installation?
Wally

1 - 2 of 16 Posts

use a jack from a truck to lift the motor gently out of the frame... should protect the frame with rags and pull it out the right

dude

even with a starter... if your bike craps out... you are pushing

hook a bungee onto tex's bike... that will get ya where ya need to go

1 - 2 of 16 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.