Cafe Racer Forum banner

CB350 engine installation

7278 Views 15 Replies 9 Participants Last post by  texmawby
I'll be installing my CB350 race engine into the frame Friday. It was difficult removing, any hints on an easier installation?
Wally
1 - 2 of 16 Posts
with the cb350 the frame is assymetrical, so it can only go in from the right side. the lower of the cradle side. it can be a litte bit of a puzzle to get it in and out, but once you do it 2 or 3 times, youll have it perfectly figured out and will be able to do it alone. it helps to stand up over it and lift it into place and out of the frame. at least for me it does. you can shove a blanket into the area to help keep from scratching it.

jc
race with wera, you get free rides from the crash truck!! much nicer than pushing from the bowl at nhis! someone should volunteer a truck or something for nhis.

jc
1 - 2 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top