Cafe Racer Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
I just picked up some of these from honda - part # 16010-344-305. It seems a little large (i.e too long) to fit in the groove that goes around the bowl. Anyone else find this?
 

·
Registered
Joined
·
23,303 Posts
if you are talking about the o-ring style gaskets, usually I put them in the freezer to contract them before installing. Once they are good and frozen, becareful how you handle them as your body heat will cause them to re-expand.
 

·
Registered
Joined
·
18 Posts
Discussion Starter #3
Tried the freezing thing. Doesn't shrink it anywhere near enough for it to be the right size. The old gasket that was in there before is definately a smaller diameter.

Jeez, and after all the keyster bashing i've read on here I figured Honda parts were the way to go.....
 
1 - 3 of 3 Posts
Top