Cafe Racer Forum banner
Cancel

CB350 Mikuni Jetting

1298 Views 5 Replies 4 Participants Last post by  ROSKO, 
M
Well I have been struggling to get my bike tuned right over the past few weeks. I used the Ohio site to get a general idea on what kind of jets my bike would need, but after switching and swapping I'm always running lean or rich depending on needle or main jets, when I hit about 6k on the rpms.

Here's my list of mods. Todds pistons, New Cam chain with slipper tensioner, Megacycle 123-20 cam, and Mikuni VM32 Carbs with velocity stacks.

If anybody has a similar setup and could throw me a bone on where to find a better start, or if you have any better ideas.
Reply
Save
Like
1 - 1 of 6 Posts
K
I'm having similar but different problems with my similar but different setup. I've got 28mm Mikunis and a 362 kit, stock head/cam (street bike) and the best I can get them after Sudco initially "custom tuned them to my bike" (a.k.a. TOTALLY way off), I keep coming up rich down low. I might look into different sliders or start all over again.

This post doesn't help you at all. I'm just showing empathy.

Honda go sideways!
Reply
Save
Like
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cafe Racer Forum
A forum community dedicated to Cafe Racer style race bikes owners and enthusiasts. Come join the discussion about restoration, performance, racing, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Bike Discussions Project Builds Technical Vintage Motorcycle Racing New Member Introductions
Top