Cafe Racer Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
5,188 Posts
From what I recall.... if you remove the bolt that holds the holder in tension with the torsion bar, the holder should slide right off the end of the torsion bar. From there, you can rotate the torsion bar to remove the valve retainers and other stuff.

But Ive been up for the past 20 hours working on SQL stored procedures. I might not be thinking too clearly.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top