Cafe Racer Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
10,541 Posts
Discussion Starter #1
http://www.makerbot.com/

just saw this on cobert
I want one!

just think that having one for making small parts would be SICK!
 

·
Registered
Joined
·
3,466 Posts
I saw plans to make one from a couple of old printers a few years ago, use UV curing epoxy, then use that as master for investment casting
 

·
Registered
Joined
·
3,466 Posts
I saw plans to make one from a couple of old printers a few years ago, use UV curing epoxy, then use that as master for investment casting
 

·
Registered
Joined
·
23,303 Posts
Jag,

Bre's offices are above Colton engineering in redhook, right by Moto borgotaro.you should read make magazine more as he used to do thier podcasts (before Kip Kay) and is a regular contributor. If you join some of the local hacker spaces you'll meet him.

Maybe not a bad place for an internship.

I met Bre at comic-con 2 years ago. Cool dude. He wouldnt know me from Adam but I was a fan.
 

·
Registered
Joined
·
23,303 Posts
Jag,

Bre's offices are above Colton engineering in redhook, right by Moto borgotaro.you should read make magazine more as he used to do thier podcasts (before Kip Kay) and is a regular contributor. If you join some of the local hacker spaces you'll meet him.

Maybe not a bad place for an internship.

I met Bre at comic-con 2 years ago. Cool dude. He wouldnt know me from Adam but I was a fan.
 

·
Registered
Joined
·
10,541 Posts
Discussion Starter #6
What the actual fuck?
 
1 - 6 of 6 Posts
Top