Cafe Racer Forum banner

cool

1557 Views 11 Replies 5 Participants Last post by  Judeyramone
I know torrey street, between packard and washtenaw right...if its the same, i know a ton of people that grew up in that neighborhood. Draw something up, or, maybe meet up and take dimensions....i don't know shit about racing or vintage bikes, but the machining part I can handle.
1 - 2 of 12 Posts
Welcome aboard,
Some of know a little bit about 350s and racing. If you want to machine some stuff we probably have some ideas about that too. For starters if you are working on a race bike, Machine a plug for the electric starter hole after you emove it. Turn down the back of the alternator rotor after you pull all the starter stuff off it. Make some exhaust flanges to replace the cast iron ones afte Branson figures out how to make cool 350 exhaust systems (you can trade him some machining for some pipes). Machine some rearset footpeg mounting brackets and footpegs with cool linkages for the brake and shifter. How about some aluminum brake stay arms? The list goes on and on and I would be happy to try outyour prototypes for you.
Check out the vintage racing at Grattan. There are lots of 350s there and several of the riders are local to you. Askaround and get out on the track.
Ken
P.S. You could make some clip-ons. Don't even think about clubmans cause Geeto is homophobic.

AHRMA 412
Vintage racing - old guys on old bikes
See less See more
Welcome aboard,
Some of know a little bit about 350s and racing. If you want to machine some stuff we probably have some ideas about that too. For starters if you are working on a race bike, Machine a plug for the electric starter hole after you emove it. Turn down the back of the alternator rotor after you pull all the starter stuff off it. Make some exhaust flanges to replace the cast iron ones afte Branson figures out how to make cool 350 exhaust systems (you can trade him some machining for some pipes). Machine some rearset footpeg mounting brackets and footpegs with cool linkages for the brake and shifter. How about some aluminum brake stay arms? The list goes on and on and I would be happy to try outyour prototypes for you.
Check out the vintage racing at Grattan. There are lots of 350s there and several of the riders are local to you. Askaround and get out on the track.
Ken
P.S. You could make some clip-ons. Don't even think about clubmans cause Geeto is homophobic.

AHRMA 412
Vintage racing - old guys on old bikes
See less See more
1 - 2 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top