[jbranson]

Hey Aaron...this has fuckin nothing to do with this topic...but since I know your giant ego will force you to read responses to your post I know you'll see this.

Don't hate me but I haven't done shit as far as PVL plates go. Every time I think of it...I think of you...which makes me think of Rossi...which makes me touch myself. So I forget about the plate.

If it's an emergency I can get it done and overnight it before Mid O.
But that will require that YOU touch me while wearing a bag on your head with Rossi's picture on it.
JohnnyB

 

[jbranson]

Aaron,
I have the block off plate and the flanges. I already have to make another meg so I'll make two.
Sounds like you are building a 240cc bike...ya bastard.

Seen these? http://www.powroll.com/P_HONDA_CB160.htm

Look suspiciously like mine. Except more expensive.
JohnnyB

 

[jbranson]

Aaron,
The 160 chamber is different enough that those couldn't be used on a 175 I don't think. And with that dome there are going to be a lot of people that smash their piston into the spark plug electrode unless they machine clearance for it.
I sure hope they aren't using the same forging I am...cause there aren't a whole lot of them left.
JohnnyB


PS. Let me know which flanges you need. The head side design, or the 24mm Keihin design.



Edited by - jbranson on Jul 11 2005 2:26:31 PM

 

[jbranson]

Rodger Dodger,
I'll get those and a plate in the mail this week. Hopefully to the right address.
JohnnyB

 

[jbranson]

Aaron,
Yep that's the address I have.

And it was nice of you to mention Donald in your post even though I know you just wanted to clarify the address. Very Diplomatic of you.
JohnnyB