Cafe Racer Forum banner
1 - 2 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
i just got a set of bikemaster drag bars for my 76' cb750 supersport. BUT,they are not equal length on both sides... one side is 11" form the slight bend and the other is 15". and of course I noticed this after i installed them and spent to much time modifying the switch housings and what not.

any ideas?


· Premium Member
7,411 Posts
That's freakin strange.
Must be a factory defect.
I'd get a pipe cutter and zip off the end where you want it. Or just hack saw it if you don't have a pipe cutter.

Hopefully it's a case of one end being too long and not the other being too short.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.