[red]

I got my Dyna S (made for GL1000) installed but my points cover won't close over it. Has anyone else done this mod?

 

[red]

I was told to rotate the dyna 180 degrees but with a small amount of grinding on the backing plate, I was able to install it correctly. Did you rotate yours? The only other issue I'm running into is the mounting screws. The stock red ones don't fit, so I need to track some down that will. Do you have a pic of the completed install? If so, I'd like to check it out.

Thanks

 

[red]

thanks!

 

[red]

they make a rubber dip/spray for tool handles. if it had a high enough heat tolerance, you could line the inside of the cover. i've never used it before, just an idea that popped into my head.

 

[red]

I rotated the dyna to match your picture. Just a quick question about the wiring. All I need to do is wiring like I would my points, then splice in a hot wire from the ignition via the resistor?

thanks

 

[red]

Thanks again! With any luck we'll have it ready to fine tune on Sat.