eliminating rear fender on a Thruxton

1754 Views 1 Reply 2 Participants Last post by ttilghman, Jan 20, 2006

jcc

Discussion Starter · Jan 20, 2006

I'm lookin into eliminating my rear fender on my Thruxton without spending $225 on the kit from newthruxton.com. I'm thinking of just getting the ABS protective plate, bullet turn singals, turn signal relocation brackets for the rear from newthruxton.com, and a single LED liscense plate holder (Back Off) from customdynamics.com.
Has anyone else done this or any other way which would be as inexpensive?
I also would like to get a louder exhaust without spending $500 on a new one. The local dealership said i could just knock the baffels in the silencers that are already on there. I'm not too sure if i want to go that route. Any suggestions?

Save

1 - 1 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.