Cafe Racer Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3,065 Posts
Discussion Starter · #1 ·
hold the applause, not my own, just a dirty re-post:

"The torsion bars should read 60 inch-pounds as a minimum, (deflecting them from neutral pressure to alignment with the guide tube that retains the end.).... I have found most will read about 75/80 inch-pounds unless they have been over-revved..... "

Haven't found any "new" specs but, better to have something...

BORN TO LURK, FORCED TO WORK.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top