[kawiracer]

I rebuilt the forks on my cb750, new seals or whatever. the manual says to use 6-6.5 oz of atf per fork. so thats what i did.

does that sound right, how can I tell if im using enough. forks seem to travel fine, i can hear a little noise from the spring inside that i dont remember from before.

any opinions.

Edited by - kawiracer on Oct 06 2007 02:23:55 AM

 

[cafeteria_racer]

Are you sure the manual doesn't give you a depth measurement. If you know what level they should be at you can dip a small diameter rod down, mark it, and measure it. Although, if you put the right amount in then you shouldn't have to worry.

 

[kawiracer]

ill check the depth thing. ive just hear guys say they used the manual suggestions and it wasnt enough after a complete drain and cleaning, so i didnt know if you could feel that or what.

My CB750 Project:
http://www.caferacer.net/forum/topic.asp?TOPIC_ID=4739

 

[joe c]

6" from the top of the slider. with the tubes completely compressed and the spring in.

jc