how to mount a pvl on a cb350

1801 Views 11 Replies 6 Participants Last post by joe c, Jan 22, 2007

joe c

Discussion Starter · Jan 20, 2007

heres the block off plate i used for my cb350. i got it from chris marshall. it carries a seal for the crank, and screws to the cases. you do have to machine that joint in the cases flat for this to work, then use tiny town screws to hold the plate in. which means drilling and taping the case. it was all pretty easy to do, but would have been a total pain the ass with out a milling machine. the plate is flanged so it kinda finds the center on its own. which makes drilling the holes for the screws simple. anyway, i said id post pics. here they are.

See less See more

Save

1 - 6 of 12 Posts

joe c

Discussion Starter · #4 · Jan 20, 2007

nah, im livin dangerous. ill just keep an eye on them. its a dry cavity, so i can pull that cover whenever. ill have to go through the thing after the initial run ins anyway. its only simple in theory. getting the bore hole perfectly aligned, then the flange perfect aint easy. then the recess for the seal. i think chris has just given up and has them made now. if anyones looking for this setup, drop me a note or chris a note. hes on the board here. hes "mr daytona".

jc

Save

joe c

Discussion Starter · #6 · Jan 21, 2007

if you mean the lower hole that oil swishes through, epoxy. if you mean is there something blocking the oil feed for the bearing, um....duh....no.

me

Save

joe c

Discussion Starter · #8 · Jan 21, 2007

i ran out, gas tank is full though.

jc

Save

joe c

Discussion Starter · #10 · Jan 21, 2007

the swisher hole, sounds like a bar in phili.

jc

Save

joe c

Discussion Starter · #12 · Jan 22, 2007

its a stock honda part. hard to find though. they dont make them any more. you can try buff harsh at todd henning racing, (google it)he should have them. or maybe toad town racing....or i dont know. i got mine from todd.

jc

Save

1 - 6 of 12 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month