Cafe Racer Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
13,810 Posts
Discussion Starter · #1 ·
ok, so im pulling apart my wheels this weekend on the 550. we opened up the backing plate to reveal a nicely installed and punched bearing retainer that has 4 notches (not nochez) machined into it to put a tool on to remove it so you can get to the bearing. it is also punched/tanged. im sure this was a factory deal. its similar to the triumph rear bearing retainer, but instead of holes, its 4 grooves cut across from each other. chris went through the tucker rockey catalog and there is no tool in there to remove the stupid thing. so, question is, anyone got one, and where did you get it from. i already checked at my local dealer tonight, and they 18 year old kid behind the counter didnt know. i figured i got him to cut some chain for me, and i wasnt going to push it. i cant balance my new tires until i can get some new bearings in. so its kind of a pain in the ass.

oh yeah, i found the ignition part i was looking for. emgo makes one just for this application! pipes come tomorrow. pics of the new scoot soon.

jc
 

·
Registered
Joined
·
13,810 Posts
Discussion Starter · #4 ·
the thing is, it doesnt have just holes in it for a "pin wrench". it has about 3/8" grooves machined in it in a cross pattern. no holes. so the grooves are 90 degrees to each other. sort of like a gigantic castle nut, but with 4 grooves. and its shallow/ maybe 3/16" or 1/8" and recesses into the hub. i was thinking something that goes onto the end of a ratchet or with a bolt on the end. the thing is, its aluminum, like they all seem to be, and its been punched at the threads in 4 places. so the seam where it meets the hub has punches or a tang pounded into it. see what i mean??? i have the triumph tool too, but its useless for this. i tried using a punch to spin it out, but it just burried itself in the retainer. i also tried a large screwdriver, but it did the same thing. the one on my bonneville screw in, then has an alan bolt that locks it into place.

id taker pictures of it, but i put it back together so i could ride it. i'll have to look at my other later wheel and se what it has. if its the same, i'll take a pic of it.

jc
 

·
Registered
Joined
·
13,810 Posts
Discussion Starter · #6 ·
i think youre right. i was looking for the real tool, but that should work fine. woohoo. thanks!

jc
 
1 - 3 of 3 Posts
Top