Into the crank case it goes...

872 Views 4 Replies 3 Participants Last post by joe c, Oct 22, 2006

savor

Discussion Starter · Oct 21, 2006

So... I lost one of the two little rubber pieces that goes on the bottom of the cam chain roller into the crank case. I just put together the cylinder head with only one of those rubber pieces. Will this cause any problems?

Save

1 - 1 of 5 Posts

736cafe

· #2 · Oct 21, 2006

i'm assuming that you are talking about a honda 350, so.......yes, it can cause problems. it can cause any number of maladies to your freshly built mill like: clogged oil channels, an unstable tensioner mechansim, the rubber/metal bit can get wedged into gears/crank parts. just to name a few. my advice, pull it apart and fish that sucker out, you can use a magnet on a stick.

scott from chicago
ahrma #527

Save

1 - 1 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.