Cafe Racer Forum banner
1 - 10 of 10 Posts

· Registered
Joined
·
119 Posts
Discussion Starter · #1 ·
I have 4(Im keeping one) One redlines at 12.5 and has a little rust on it. The other one redlines at 11.5, I will send you whateverone you want UPS. I will also send along the holder,It looks like it will mount good with it.
 

· Registered
Joined
·
11,783 Posts
woohoo! give me whichever one looks the nicest. either will do rpm range wise since my bike only revs to about 9500. i dont really need to outer casing. but if you have it i'll take it. if thats whats got the rust on it, i can repaint it. if you get me ups total, i'll drop you out a check.

i'll drop you an email with my address.
you da man!


thanks a million.

jc
 

· Registered
Joined
·
41 Posts
quote:
I have 4(Im keeping one) One redlines at 12.5 and has a little rust on it. The other one redlines at 11.5, I will send you whateverone you want UPS. I will also send along the holder,It looks like it will mount good with it.
If you have 4 and are keeping one, sending one of the remaining 3 to joec, I would be interested in one of the remaining 2.....
Peter B (In snow covered New Hampshire)

76 GL 1000
72 CB350 Racer
84 RZ 350
(and a few more)
 

· Registered
Joined
·
41 Posts
quote:
Peter,
The one I have left is no good, I think? It is stuck at 2k and has a little rust on the bezzel If you want it ill send it to you
Well I suppose if it is stuck then it would be of no use to me either..... I'm going to use it the same way that Joe is.
Thanks for the offer though,
Peter

76 GL 1000
72 CB350 Racer
84 RZ 350
(and a few more)
 

· Registered
Joined
·
41 Posts
quote:
i highly doubt youre going to use it the same way i will.


jc
Well now that I think about it, if it's not going on that zebra stripe seated CB350, probably not (anything else, I really don't want to know, but I don't think you can do better than 100 RPM)

76 GL 1000
72 CB350 Racer
84 RZ 350
(and a few more)
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top