Cafe Racer Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2,355 Posts
Discussion Starter #1
i am doing a rewire on my xs400, i am eliminating things etc. have a fairly organized schematic made up, sort of know how my wiring is even going to run. but i have a few sports where one power wired splits, or two things are sort of connected but the both share a supply line. whats the cleanest, most vibration friendly way to split say a 16 guage wire into three 18 gauge wires?
 

·
Registered
Joined
·
123 Posts
you can get MSD terminal strips from summit. they're like $7 a piece. common sense and prudence rules their use. general rule of thumb...no more than 3 wires per terminal, if you need more, run a jumper to the next terminal and go from there. kinda like so:

 
1 - 2 of 2 Posts
Top