Cafe Racer Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
148 Posts
Discussion Starter #1
ok, finally got this thing taken apart... it was jb welded i think??
so here it is for any of u riders that want one.
judeyramone- would have dibs though. since u asked about it b4 i even took it off the cl360




03 rsv Tuono (STARF8R)
75 cl360 ("Chupa"thingy)
2000 Ninja 250r ("chibi")
 

·
Registered
Joined
·
13,809 Posts
wonder if that'll fit on a 550 chasis.

whats the distance between the bars?
 

·
Registered
Joined
·
148 Posts
Discussion Starter #3
the two bolt holes that go on the upper shox bolt are 11.5 inches across outside to outside and the adjustable slides have two holes each 9.5 and 6.5 apart. then there are two of the same adjustable slides on the rear that have alot of mounting holes.
on my cl i used the two for the upper shox and the two at the back and attached them to the tag holder. it was solid as a rock!

03 rsv Tuono (STARF8R)
75 cl360 ("Chupa"thingy)
2000 Ninja 250r ("chibi")
 
1 - 3 of 3 Posts
Top