Cafe Racer Forum banner

make you own damn seat..its your arse!!!

917 Views 1 Reply 2 Participants Last post by  UngaWunga
Hey here is a tech how-to on making a seat ,for you steel, doit yourselfers. Its almost the way I do it.I just dont make a mold out of it ,it ends up the same way any way .

Just a tip for the home builders that attempt this :weld from the underside, gives you a smooth out side appearance and saves a lot of grinding.For the makes it hard to grind down welds.Its why its called custom fabrication .you make it your way.
Any way its cool .here you go.

I found the link here and other usful tid bits

Edited by - LiLBull on Dec 20 2005 08:57:43 AM
1 - 1 of 2 Posts
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.