Cafe Racer Forum banner

Mounting Plate

2620 Views 31 Replies 6 Participants Last post by  jbranson
Hey Mr. Branson,
You sent me the drawing for the PVL mouting plate right? I'm reorganizing and can't find it.

Cheers, Aaron
1 - 2 of 32 Posts
I need to make an offset motor sprocket for a wide tire cafe/fighter I am building. The bolt needs to be recessed so it will fit the shaft. Think you can help me with it? if so let me know.
yeah he had the pesky pertonix on the crank with a block off plate by you . . . he posted phtos of it. Good idea, but the PVL is better . . .
The PVL has advance built into it, right?
Does the Pertonix?
1 - 2 of 32 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.