Cafe Racer Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4,508 Posts
Joe,

Get a better manual. In my factory shop manual, page 34, figure 4-20, explains this.

Note: The eccentric indicator cutout "A" of the rocker arm pin must be rotated so that it it to the outside of the screwdriver slot "B" (opposite the contact points) as shown in Fig. 4-20. This setting is the same for both the right and left cylinders.

Then there's a nice drawing in figure 4-20 that shows what all of this means.

I just happened to have my manual sitting here on my desk, I didn't have that all memorized.

Craig
 
1 - 1 of 1 Posts
Top