Cafe Racer Forum banner
1 - 1 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hello all

I have a 77 Honda CJ360T, pretty much completely stock.

I would like to replace the rear springs and the forks with stiffer, meaner components. I am looking to do as much of this at home as possible; don't have the means to weld and I don't want to do any cutting and drilling if it can be avoided. I am hoping to just bolt stuff on.

Can anybody offer tips / tech advice, as well as whether parts from other, more readily available bikes (e.g. the CB 750) will be a direct swap?

Thanks in advance.

Edited by - brain_bucket on Feb 04 2005 3:09:18 PM
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.