Cafe Racer Forum banner
1 - 2 of 2 Posts

222 Posts
Discussion Starter · #1 ·
Hi Gents:

I finally got my website up and running--well most of it anyhow.

I also got quite a bit of time in garage. I loaned my MIG machine out and was left with my TIG, which is fine, except I have very limited TIG experience. I really should have practiced more, but I didn't wait. TIG is much more complicated. Just when I started to get it, I'd dip the tungsten into the pudddle or I'd jam the filler into the tungsten. I eventually got the jub done properly, but it looks like shit. The good news is that it doesn't look worse than Yamaha's welds.

Anyway, check out the project and let me know what you think.

--Thanks, Chris
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.