Cafe Racer Forum banner
Cancel

Rim corrosion? Old anodize? Clear coat?

913 Views 5 Replies 4 Participants Last post by  ROSKO, 
Diamondj
All,

I have a set of flanged rims I want to use but I'm having a tough time cleaning them up. They are relatively shiny but there is a clear mottled/non-shiny pattern with some dark spots all over the rims. I figure the darker spots are corrosion but I'm not sure what's causing the other spots. Could it be old anodizing gone bad? Or clear coat? I tried a coat of aircraft stripper on one rim side and it did seem to remove some of it.


Any ideas? What's the best way of cleaning these up?

Thanks!

Jim
See less See more
Reply
Save
Like
1 - 2 of 6 Posts
Diamondj
Hey Rosko,

I was thinking about this. I actually have one Akront that's so grungy and corroded I think it would take a lifetime of elbow grease to get it clean. If you're willing to take a shot at it, email me a mailing address and I'll send it to you for cleaning.

Thanks,

Jim
Reply
Save
Like
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cafe Racer Forum
A forum community dedicated to Cafe Racer style race bikes owners and enthusiasts. Come join the discussion about restoration, performance, racing, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Bike Discussions Project Builds Technical Vintage Motorcycle Racing New Member Introductions
Top