Cafe Racer Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
18 Posts
LUKESTER, did you see my response to your post on the Jockey Journal?
Easy:

 

·
Registered
Joined
·
23,303 Posts
What CPGB posted is the best way to run internal wiring on clubmans. too many people try to run them down the curved portion and the wires wear out from vibration and short the bike out....ask me how I know....
 

·
Registered
Joined
·
20 Posts
Discussion Starter #6
quote:Originally posted by Geeto67

What CPGB posted is the best way to run internal wiring on clubmans. too many people try to run them down the curved portion and the wires wear out from vibration and short the bike out....ask me how I know....
Thanks. Guys. I would like to see if I can find some adjustable Tommaselli clubmans.

Where can I get some long shrink tubing like that?
 

·
Registered
Joined
·
18 Posts
I get the 3M heat shrink at electrical supply stores. There's one here in Fullerton, CA called ORVAC, I think any REAL industrial hardware store should carry it as well. Comes in many colors and sizes, I think this was 3/8" or 1/2".
 

·
Registered
Joined
·
69 Posts
In response to the way CBGP did it, that's f-ing awesome man. It actually took my a few seconds to see the wires, very clean.
 

·
Registered
Joined
·
18 Posts
just make sure you clean up the hole you drill with a small, fine files. Burrs are bad.
 
1 - 9 of 9 Posts
Top