Cafe Racer Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
4,350 Posts
i'm iccup (ow that hurt's) tryingto (ow that hurt's) smoke a (ow that hurst's) cigarette (ouch!! that HURTS) before i answer yo (Damn Ihiccuppd again [ouch] that hurts)

aaron
 

· Registered
Joined
·
4,350 Posts
haha. i am putting the needle bearing cam ends back in to my engine. First i have look and see how they're getting oil, and whether or not the oil supply was modified when the needle bearings were installed. I looked on the stock ones, and man, that hole is small.

I've been dreaming at night about an oil supply line to the head . . . .
 

· Registered
Joined
·
4,350 Posts
ok ok im the one begging now. Will pay almost anything. Outside oil cover on right side. Mines bunged up again. Aaron/ jB? BFD? my supply of them is gone.

scott
 

· Registered
Joined
·
4,350 Posts
I'm a keeping my eye out for em now, JB. I had another, which I may be forced to use, if you do not have one for me, but it is damaged and I'd have to JB weld it on. If you do send me one, there will be a special package on its way back to you . . . But it won't be smokes!!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top