Cafe Racer Forum banner

1 - 20 of 45 Posts

·
Registered
Joined
·
189 Posts
Discussion Starter #1
What tap do i need to do this and do i have to pre drill the holes into the block before i tap them cause the bolts are huge! Any info will be helpful..

Thanks Red
 

·
Registered
Joined
·
659 Posts
Drill 8.8mm (11/32") and then tap to M10-1.25.

Oil runs through some of those as well. I would think you would have to make new locater pins also.
 

·
Registered
Joined
·
659 Posts
Drill 8.8mm (11/32") and then tap to M10-1.25.

Oil runs through some of those as well. I would think you would have to make new locater pins also.
 
1 - 20 of 45 Posts
Top