Cafe Racer Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I tried to re build my 79 Yamaha sr500 carb which came with a stock mikuni vm34ss carb and just when I thought I had it about finished. I found that I have an extra part. I cant find it in a single diagram and when I take apart my identical mikuni carb, I cannot locate it. Can anyone help tell me what this part is or where it goes?? Your help is greatly appreciated!
 

Attachments

·
Registered
Joined
·
6,336 Posts
Unless the hole for your low speed adjustment screw was plugged to prevent adjustment, I think you maybe found a part that does not belong to the thing you took apart. I've done that before.
 

·
Banned
Joined
·
258 Posts
Have a look at your slide linkage again.
If its anything it looks like number 39 in the attached pic. Therr are two parts that sit either side of a ball joint for the internal slide linkage.

I could be completely wrong and speaking out of my arse but thats the only thing in your carb that i think looks like that

Give us some dimensions too as its hard to tell scale from the picture.
 

Attachments

1 - 5 of 5 Posts
Top